Daystate airwolf mvt servicing prices

[jim caffery]

Is this a common occurrence with the Wolf then???? A lad at the range I use has this issue and has asked me to service his rifle.But I advised him to go to Daystate as I had heard they fit the newer circuit boards.Thing is his only acts up when the pressure is down a bit,not when the the tank has just been refilledI put this down to the regulator but not too sure that it is not the circuit board or a dodgy setting.

I don't honestly know, I have read that when daystate have serviced other people's rifle that they fit the latest board, so I was thinking that was the way to go, I will have to find the funds from somewhere

[haloutdoors]

I had the very same problem with my Air Ranger, luckily it was within the warranty period but after three trips to the factory it still came back the same. They realigned the barrel and ended up replacing it but it was still rubbish so in the end I had it swapped from .20 to .177 by a great guy on here.
So he told me there is a very specific way and sequence to aligning the barrel on them and if not done correctly you will be shaving the pellets as they enter the breech.
For a change from left to right handed and the caliber swap plus service was less than £100 but that was last year. Very nice guy and excellent at his job.

HTH. Hal

[NoWayNoHow]

Hi Jim, Dave can do everything and anything with regard to most guns. He has a Daystate history and was up until recently the only person who was allowed to do Daystate warranty work (that may still actually be the case). He also tends to do the stuff they can't sort out for whatever reason. He can fit the circuit boards without an issue.
Regards Andrew

[missfire]

I had this with my FAC Mvt.After much fiddling n checking I found that the stock fixing bit that was attached to the mvt was loose. Ya know the bit that the one n only massive stock bolt screws into.