Thanks members I have my set of punches and a 7/16 punch looks about right for .44 cylinder so which way do I punch felt through is it fury side up or flat side up and what do I use as a backing if hard wood what's it's name I did have a go last night disaster the punch went through felt and wood which was soft wood
So what and how do other members make there own wads
My felt is 3mm thick so is it ok if wad is to be thicker to use two of these this would give me 6mm
What's your thought on this Thanks for all you help in my posts simple questions to you but for a new person it's hard to figure out sometimes thanks from Frank