bump.
£40 posted.Works +fires ..177cal.Frontsight missing ,otherwise complete + working .Stock has been refinished,average job.Blueing on action worn.If I dont reply immediately its not lack of interest but because I dont have regular access to a computer.
bump.
I'll take this please... PM me your details for payment - bank transfer probably easiest.
Thanks - JB
They do a rear-synthetic-bearing piston on the recent versions of this ... and with its barrel-latch, its like a poor man's LGV!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
http://www.czub.cz/zbrojovka/cz-spar...via-634-cs.pdf
I think it should fit the 631... the peeps on the Canadian airgun forum seem to think so. Shorter piston, so more air to push out.
Of course it doesn't have the 'Crossrail' designed TP like the LGV, but you can't have everything...
Last edited by Hsing-ee; 24-07-2014 at 08:00 PM.
Well the gun arrived - very nicely packed thanks APDT
Really quite nice - I would say under-rated, but most folk seem to like them.
530 fps with superdomes, and a very nice firing cycle. Has a decent quality feel, and is more adult sized than I expected. Being picky, I'd like a beefier barrel lock up, and a rubber recoil pad. But it's very solidly made - much better than my mk5 meteor, for example. Breach bolt with locking screw. The trigger is basic and single stage, but far superior again to the meteor's (lighter, and smoother). But for the money
Plan to scope it up with this: http://www.airgunbbs.com/showthread....ope-and-mounts
...but I'd also quite like to find a foresight to fit it's 7mm barrel dovetail - any ideas anyone ? Doesn't have to be original.
Will give it a spit and polish tune, but it really doesn't feel like it will need any real work at all. Keeping the original mainspring as is.
Thanks again for a good deal - JB
Chambers stock the front sights for these. Not very cheap though.
https://www.gunspares.co.uk/products/24503/631/
CZ 200T/200 S Hunter/200 S Green/Slavia ZVP/612/614/615/618/620/622/624/625/627/630/631/634/ZVS Perun 734/CZ236-1/Tex3/86/Brno ZII/ZV3/ZV4/VZ47/APP661/Relum/Mars 618/Stella 518/Predom 188/170/Yunker 1/2/Lov21/Baikal IJ22/IJ38/Vostok/IZH61/IZH53M/MP512M/MP654K/MP661K
CZ Barells are very good and fitted to Slavias I beleve, enjoy.
Yeah, looking forward to seeing what it does scoped
Ahh well... you know I mentioned it will just be a spit and polish tune..?
Hmmmm, it wont...
Port is 3.8mm x 21mm so that's getting sleeved down for a start - somewhere in the 2.5 - 3.0 mm range
Piston washer was a big rough, so I'm cutting the nose off and converting it to take an HW seal, which will probably add about 1/4" of stroke too
Will need to slightly lengthen the cocking slot in the piston to accommodate
Spring I will keep, but the guide could do with being a little tighter.
Will let you know how it goes
I did my tune up and gave it a new thread:
http://www.airgunbbs.com/showthread....ports-are-bad)