Reply With Quotethe hw97 uses something like a cross between a cheap carpet and a piece of kitchen toolOriginally Posted by Arthur John Smithsplease
Happy Old Goat
Hair curlers I know about, though there isn't much room in the LGU to use more than two cut pieces. What about dampening material. Felt, foam or something else?
How about a washer in the middle? Haven't measured the tube yet. Does anyone know the dimensions?
Arthur
I wish I was in the land of cotton.
Admin's pet.
the hw97 uses something like a cross between a cheap carpet and a piece of kitchen tool
Banned
m6 x 20 washers, some curlers and some felt from a craft store.
Happy Old Goat
Thanks.
Arthur
I wish I was in the land of cotton.
Happy Old Goat
What do the 6 and 20 in M6 stand for, Tony? I assume it's 20mm outer diameter, 6mm inner diameter. Isn't there a danger of clipping with such a small hole?
I've found them on the web with an internal diameter of 6.5mm. Would that be OK or do I need a slightly bigger hole.
They only sell them in hundreds on the web. Any shops like Screwfix, B&Q etc. likely to have them?
I assume you divide the silencer into three compartments, using two washers.
Last edited by Arthur John Smithsplease; 23-08-2014 at 01:31 PM.
Arthur
I wish I was in the land of cotton.
I stick my head out and take it on the chin.
The Bay, item number: 291201194836
AA TX200 MK2 .177, MK3 Barrel, long stroked & shortened T/P
AA TX200 MK3 HC .177, 22mm internals, shortened T/P
http://www.anstonftc.co.uk/
Posting Permissions