HW80 rough transfer port

[oliver13]

That's all worth knowing about. I've got a couple of small size Emery grindstones that I've looked at occasionally, but it's putting them on a 35cm shaft & then sticking it down the compression tube that's putting me off. It would be very easy to go wrong & stuff the lot.

[bigtoe01]

I made up a long T bar reamer holder from silver steel....dead easy to take TP's out now from 3 to 4mm (slight taper)

took me 20 mins to make it and cost 4 quid + the reamer....often making the tools to do the job is more rewarding than doing the job

[Snooper601]

I made up a long T bar reamer holder from silver steel....dead easy to take TP's out now from 3 to 4mm (slight taper)

took me 20 mins to make it and cost 4 quid + the reamer....often making the tools to do the job is more rewarding than doing the job

And builds up a good stock of very useful gubbins.

Cheers

John