HW100 Pre-Quick Fill Adapter

[Jimbob 2705]

Hi All,

Need to get an adapter for a HW100 Pre Quick Fill (Looks like this : http://www.bestfittings.co.uk/shopexd.asp?id=194) to fit a 1/8" Fill Line.

Would this be what I need : http://www.bisley-uk.com/product_v3.php?i=S211&c=354

?

Many Thanks,

James

[Jimbob 2705]

Or do I need a 232bar adapter?

[Bladerunner too]

Not sure what you need,but the Cylinder (not a quick fill) must have a valve in it to hold air,Correct? an i guess you are filling that by a (divers) bottle, therefore can you not just get a connection to fit between the bottle hose an the cylinder ?

[Bladerunner too]

Just looked at your links (again) an i think you are right, providing you have the correct thread sizes ,

[richierich]

Yes, that is what you need

[Jimbob 2705]

Thanks, my concern was the 232/300bar fitting, as I read the 300bar has a couple more threads, so I'm thinking it could possibly leak?

I'm just thinking if the HW100 filling adapter is 232bar and the adapter I get it 300bar - will it leak?

I was looking at the top of here, and I see there is a spacer...so it looks like I could be correct : http://www.airgunbuyer.com/Showprodu...20For%20Rifles

[richierich]

It will fit fine.

It refers to 300bar as that is what most DIN threadded bottles are. The 232bar weihrauch fitting that screws into this will fit fine, and as you are only filling to 200bar, it will not cause any issues froma 300bar tank. But i presume you are using this to connect to a pump?

[richierich]

Or try this if the one in your first post is too expensive: http://www.sportwaffen-schneider.de/...ducts_id/13297

[brucegill]

don't you just screw the big brass bit into your air bottle directly, so no whip?

Either way, find a local hydraulic shop and they'll have an adapter nice and cheep.