Originally Posted by
Eidem
Cheers for the replies gents!
As I am looking closer at the assembly I notice that the pins holding the parts
in the assembly are not held in place with the usual E-clips, they seem to
locked by being "hammered" at the ends.
Any issues or special tricks removing them, or will I be fine just driving them
out and later just knock them back in again?
Cheers!
They are hardened pins and just held in by friction. Some are so loose that they almost fall out, while others have to be "persuaded" with a hammer and pin punch.
Neil
Current airguns:- Steyr LG110: Steyr LP10: Air Arms HFT500: Weihrauch97 fully customised.