Hi guys
I have recently purchased a Webley Falcon with the idea of restoring her to former glory, she has been butchered a bit and the forward Trigger guard screw has been replaced with a metric stud welded to the action, I have ordered a new webley screw from Knibs but need to know what the thread is so that I can drill and rap the action to accept it - see fig 1
Also the Stock screws that hold stock to action had been replaced with a metric bolt, I have ordered the correct screws from Knibbs but again I need to know the thread size so that I can weld up, drill and tap to accept - see fig 2
Fig 3 shows gun as I bought it - any help with these sizes appreciated - am presuming they are old imperial perhaps BSF?
Fig 1
Fig 2
Fig 3
shellymad hi; the thread sizes for your W & S Falcon Rifle are as follows:- front stock screws 3BA drill size recommended 3.45mm
rear stock screw / front gaurd screw 0BA drill size recommended 5.1mm
I have full thread specs. if you are interested but that is the basics for you to do the relevant repairs.
Also see pm
Hope this helps
abellringer