Quote Originally Posted by Rich View Post
I know you were after something simple, but I was having a think how to get rid of those reverse bends in the spoke.

I tried having one simple toggle lever but the movement would be reversed, I mean, pulling the trigger at the finger end would push the actual blade forwards and not back; too difficult.

Here's a concept idea; the green fulcrum points would need to be supported by a bracket fixed with the screws that hold the trigger guard on.

Look's complicated, why not do away with the two pivot levers and just use a continuous rod like i have if supported correctly it wont flex.



The only pivot in this set up is the factory trigger, if your're worried about flex use thicker rod..