Registered User
OK, this morning I received my CP1 9 shot mag from Alice at Silesia Shop, very nice people BTW,
and it has the bolt on the left side, I thought it was on the right, it is in the pics.
The trigger which I was going to modify in the forum fashion already has a threaded hole in it, but no screw. IS THIS NEW or am I wrong?
If I fit an adjusting screw do I adjust the sear above or the stop below? I need a little advice.
I also thought the muzzle was threaded, not this one!
http://i300.photobucket.com/albums/n...psafe9rb9d.jpg
http://i300.photobucket.com/albums/n...psgsni94qz.jpg
Any comments will be gratefully received.
Last edited by richardlce; 14-07-2015 at 12:05 PM.
Registered User
Hi my standard single shot cp1 has no thread and the bolt is on the right (Idone the meds as per this fine forum and shoots very well ) the trigger pull was packed with a spacer to make it further back in the trigger guard , cant see the hole in yours doing much even with a bolt in it ? don't know a huge amount about them but is not the same as a standard cp1 single shotOriginally Posted by richardlce
regards
scott
Horizontally Challenged
Have seen some pics where the bolt was on the left- pretty sensible idea TBH- wish they had done it sooner. Had heard that the multishot now sports an adjustable trigger, but can't remember where- possibly the UKCAGF? Threaded muzzle is a new one on me, none of the single shot versions have this. Only other thing I have heard is that the multishot mags can be a bit "iffy"
Registered User
The mag is fiddly to load, and damages pellets in use and the problem is the spring.
It is very hard, I think it is too short, it needs to be longer and softer then it would be easier to load up and wouldn't damage the skirt of the pellet on the way out. I will see if I can find a suitable spring somewhere.
Otherwise it it an excellent gun, it works fine with the single shot tray supplied.
Posting Permissions
Reply With Quote