Does any know what make of powder ppu use in the bullets particular the swiss 7.5x55 fmjbt. thank you
Does any know what make of powder ppu use in the bullets particular the swiss 7.5x55 fmjbt. thank you
God only knows, they are Serbian though.
Why not drop them an email and ask?
I'm a maggot in another life you know
You Cannot Reason People Out of Something They Were Not Reasoned Into
"Politicians like to panic, they need activity. It is their substitute for achievement" Sir Humphry Appleby
Even if you knew the information it would be of little use, would even be misleading. Ammunition manufacturers buy powder in multiple ton quantities; not by the pound! They therefore specify what they need from the powder manufacturer. Usually based on a standard military specification (the military are the largest consumers) along with a list of custom properties such as slight changes in density, deterrent coatings granule size and so on. An often quoted example of this is the case of Green Dot, of which Hercules (now Alliant) made at least four different versions; one (canister) for the consumer market and three for commercial ammunition loaders. The difference in the versions offered for commercial loaders was chiefly one of bulk volume in order to compensate for variations used space in shot gun ammunition arising from the differences in volume of of shot of the same weight but different size. An once of No. 9 will take up less room than an once of No2 shot.
For the reloader, who uses canister powders, the powder has to be manufactured to be as close as possible to a design standard so that when that jug of N140 you bought over a decade ago runs out you can go on to use N140 that was made a month ago with a fair degree of confidence that the performance will be consistent.
The Swiss did not use ANY kind of Reloader propellant in GP11, last produced in 1992.
tac
swissrifles.com
You Cannot Reason People Out of Something They Were Not Reasoned Into
"Politicians like to panic, they need activity. It is their substitute for achievement" Sir Humphry Appleby
To be honest (and hopefully helpful) I would see what powders those reloading for this chambering are useing, then see what is the most available, then worry about cost (depending on whether I was shooting lots of it).
There is no point trying to replicate something you may never be able to get (or get on every day with an X in it).
If you can get it, and you are not shooting much, buy a couple of cans and go for it.
If you are shooting a lot of it, then maybe you might have to pay a tad more if the powder of choice just happens to be readilly available....itc catch 22 in that department really, thats why a lot of high volume shooters buy powder in 3,5 or 20Kg drums if they can do it.
I'm a maggot in another life you know
Powder in the bullets? The bullets are just lead with a jacket made from a copper / zinc alloy.
If you are asking what powder they use to load their ammunition that is different, but as already stated not very useful because ammunition manufacturers do not usually use the powders that come in retail packs. Basically they buy the powder by the hundreds of tons so they specify the properties of the propellant they need rather than load to the propellent available.