Webley Eclipse trigger

[philcbr]

Need some help with the re-assembly of a Webley Eclipse trigger. I have fitted a new main spring now the gun won't stay "cocked" the safety pops out like before but that's it. I can set the trigger by hand ok and it works as it should but the piston is not being held in the compressed state.
I’ve tried to find a diagram of the trigger unit but can only find a parts list type drawing, I need one on how to assemble the unit from scratch.
Hopefully one of you experienced springer shooters can help.
Many thanks
Phil.

[Phil Russell]

Hi
I have sent a copy of the manual to your e mail address. Hopefully it will help.
In the meantime make sure the rifle is not coil bound as I note you fitted a new main spring. Check number of coils and wire guage against the original spring to make sure your new one is not offering a greater compressed length. After market springs, particularly of the Titan variety often need to be reduced in length by a few coils to both make them fit and to ensure you do not end up with a rifle that is over 12.
Cheers, Phil

[philcbr]

Hi Phil

I have received the Webley Eclipse manual ok, thanks very much
I have counted the number of coils on the old spring and the new one is the same it's just a little bit shorter due to age. I bought a "standard" spring from John Knibbs so it should be the right one.
I'm going to check the assembly of the trigger again just to make sure it's correct.
Once again many thanks.

Phil

[philcbr]

Well i've had enough for today, its got me beat ......try again tomorrow.

[venoman]

Re fit the old spring and see if it cocks, i done a strip down and rebuild of this rifle in Feb/March 2014 Airgun Shooter this also told you how to rebuild the trigger.

[philcbr]

Hi Venoman,
Any chance of a copy of the article you wrote, especially interested in any photos or diagrams. Since disassembling the trigger again I'm having difficulty deciding where the trigger return spring locates? I can’t decide where it anchors?
Thanks
Phil

[Tony Clements]

Hi
I have sent a copy of the manual to your e mail address. Hopefully it will help.
In the meantime make sure the rifle is not coil bound as I note you fitted a new main spring. Check number of coils and wire guage against the original spring to make sure your new one is not offering a greater compressed length. After market springs, particularly of the Titan variety often need to be reduced in length by a few coils to both make them fit and to ensure you do not end up with a rifle that is over 12.
Cheers, Phil

My name is Tony Clements, I'm a new member and I am currently looking at four major bits, two or three springs and 5 pins with securing clips. It seems that your manual might help to sort my problem?
Your help would be greatly appreciated.
Cheers, Tony C

[Tony Clements]

Hi
I have sent a copy of the manual to your e mail address. Hopefully it will help.
In the meantime make sure the rifle is not coil bound as I note you fitted a new main spring. Check number of coils and wire guage against the original spring to make sure your new one is not offering a greater compressed length. After market springs, particularly of the Titan variety often need to be reduced in length by a few coils to both make them fit and to ensure you do not end up with a rifle that is over 12.
Cheers, Phil

My name is Tony Clements, I'm a new member and I am currently looking at four major bits, two or three springs and 5 pins with securing clips. It seems that your manual might help to sort my problem?
Your help would be greatly appreciated.
Cheers, Tony C