Results 1 to 3 of 3

Thread: Morini 162 shooter with a vernier needed

  1. 12-08-2015, 09:34 PM #1
    nige346
    nige346 is offline Registered User
    Join Date
    Jun 2012
    Location
    swanley
    Posts
    1,707

    Morini 162 shooter with a vernier needed

    Could someone with the above pistol kindly measure the diameter of the cylinder mounting point, I would like if possible to fit the under cylinder weight bar that is designed to fit on the 162 cylinder mounting to my LP2, problem is I have no idea if the mounts are the same size and the weights bars are too expensive to take a gamble. (Unless anyone has one for sale) measurement needs to be accurate so a job for a vernier guage.

    Cheers in advance
    Nige
    Steyr LP10, Steyr LP5,
    Vintage Collection - Walther LP53, HW77k Venom, BSF S20 Match, Original 35, ASI Target plus lots more
    Reply With Quote Reply With Quote
  2. 13-08-2015, 08:35 AM #2
    niloc
    niloc is offline Registered User
    Join Date
    Oct 2009
    Location
    Fleet in Darkest Hampshire
    Posts
    1,180
    Assuming you mean the diameter of the regulator housing then it is 29.8mm on mine so a nominal 30mm

    Hope that helps

    Colin
    Reply With Quote Reply With Quote
  3. 13-08-2015, 03:34 PM #3
    nige346
    nige346 is offline Registered User
    Join Date
    Jun 2012
    Location
    swanley
    Posts
    1,707
    Cheers Colin,

    your a gent
    ATB Nige
    Steyr LP10, Steyr LP5,
    Vintage Collection - Walther LP53, HW77k Venom, BSF S20 Match, Original 35, ASI Target plus lots more
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules