nipple stuck in cylinder

[gtpkeeper]

pick up a westner arms new army
and found one of the nipple stuck in cylinder, my nipple wrench just slips around, any ideas

[enfield2band]

pick up a remington and found one of the nipple stuck in cylinder, my nipple wrench just slips around, any ideas

You could try a small extractor that has a left hand thread. Or, you could get a left handed tap and thread the nipple and the screw in a left hand threaded bolt and it should unwind the nipple. Make sure the bolt is of high tensile steel otherwise it might snap or strip the thread.

[bfhb]

Also make sure you soak the thing in some sort of penetrating oil for a while to make things easier.

Mark

[gtpkeeper]

cheers guys,i soaked it on oil overnight,sides of the nipple pretty much rounded of,
never used them tools before,

[enfield2band]

There is another way you could try but you risk butchering the nipple completely.

If you have got a small round file, remove the handle and the tang is usually a tapered square section. If the end is small enough you can tap it into the nipple and then, with a small set of mole grips, you could try turning it and it might release the nipple.
If it does not work almost straight away then I think you will need to find someone that can remove it for you.

It is possible that the thread exposed in the chamber is all that is corroded. If it is only that, once it has moved a fraction it should wind out.

It is reckoned that if you keep removing the nipples to clean the gun it can wear the thread and cause gas cutting.The hot gases can pass up the side of the nipple and burn away the thread on the nipple and the cylinder.
Once you have cleaned the gun and it is dry it would not do any harm to release the nipple, without unscrewing it, so that if any corrosion does appear while it is in storage it will not seize the nipple.

[gtpkeeper]

cheers for ya help
ill let you know how it goes,
ive always removed the nipples on my bp guns and spray with bit of brunox