Crosman Medalist 2

[freewind]

Could someone point me in the right direction to get a replacement quad seal or perhaps a re-furb part. The O rings seem to be obtainable but the quad thingy is proving a bit more difficult. It would be nice to get this `70s pump up pistol working again.

Hopeful , Andy

[gingernut]

Try T R Robb.

[Dan944]

Get intouched with gmac mate. But don't get carried away

All the best
Daniel

[T 20]

Could someone point me in the right direction to get a replacement quad seal or perhaps a re-furb part. The O rings seem to be obtainable but the quad thingy is proving a bit more difficult. It would be nice to get this `70s pump up pistol working again.

Hopeful , Andy

I just use a metric O ring instead of the quad seal.



All the best Mick

[gedfinn 2]

Could someone point me in the right direction to get a replacement quad seal or perhaps a re-furb part. The O rings seem to be obtainable but the quad thingy is proving a bit more difficult. It would be nice to get this `70s pump up pistol working again.

Hopeful , Andy

I have one, & A 2250 Crosman converted 8+ Years ago !
Both converted to Hpa, ( 2000 Psi ) I could not control the Fpe output above this ?( Originally at 3000 Psi )
20-25 shots at 6 Fpe ( 12 shots on the 2250 in rifle form at 11 + Fpe ) Suprisingly same shot count on the rifle due to the longer barrel.



& a couple of 15 + year old conversions


& an " Active piston " Webley Tempest Hpa or Co2 ( 6 Fpe ) Obviously.


A finished ( 5 Years ago ) Crosman 2250 + Silencer )


At nearly 67 I am no longer up to pumping ! Ha ha.

Ged.

[freewind]

Cheers for all the good info guys . Spoke to the guru today . Lawrie has led me on the path to a `70s beauty that is shooting really sweet. The quad seal was the key for me , the old one was replaced by an O ring which I was lucky enough to have loads of and rest was just fettling.
Thanks again everyone , lots of knowledge on the forum to be tapped.

Andy