STOP

Don't start lopping off coils.

It's most likely a tight piston seal.

Take the rifle apart. Take out the comp tube and the piston. Degrease. Hold the rear end of the piston rod in your thumb and finger and see if you can slide it easily in and out. If it takes some pushing in or pulling out then it's too tight. It should slide in and out easily with just the tips of your thumb and finger. If you stand it up with the comp tube down and the piston rod at the top I wouldn't want it easily falling under it's own weight. I would want to be able to gently push the piston rod down with the tip of a finger and it falls easily.

Put a Marigold rubber glove on. Pull the piston back so that it draws air in through the transfer port. squeeze a finger or thumb over the TP hole and try and push the piston forwards. It should go a short distance and then you should hit resistance from the compressed air. When you let go of rod it should bounce back slightly.

If the seal is obviously too tight then I wouldn't waste time and pellets trying to shoot it to size. I chuck them up in a normal hand drill via the end of the piston rod. Then place some very fine Wet n Dry around the piston seal. Wrap it around so you are contacting all the circumference of the seal as best you can. Start the drill spinning ( maybe hold it flat on a table with the trigger locked on ). Use a curled finger and thumb to gently apply pressure around the seal with the Wet n Dry. Just a couple of seconds and retry in the comp tube ( let it cool for several seconds before trying ). Keep doing this until you achieve what I described above ( easy slide fit ).

When you are happy then re-lube and refit to rifle and retest power.

Also check the spring guides. Are they a tight fit inside the spring. Different opinions here ... some like them quite a firm fit so they will be a slide fit when the spring is compressed ( gun cocked ). I have them so they slide in and out quite easily. Certainly not a gravity fit but no real friction. If you have to push and pull hard to get them in and out then they are too tight in my opinion. This will also steal power.

Do these things first before you start chopping coils off.

Good luck and let us know how it goes.