Registered User
My Anschutz 220 has part 12 missing. It's the latch that holds back the piston when the action is cocked. I have found an engineer who is making one from a drawing,however he has run into a bit of a snag with a couple of dimensions that weren't on the drawing, namely the chamfer to the centre hole.
Would any owner be prepared to remove their part 12 and let me borrow it, so he can complete the ones that he is making.
A couple of pictures of the part 12 - You can just see the chamfer on the part 12
If you can assist please pm me
Thanks
Last edited by Mark D; 23-01-2016 at 06:37 PM.
Registered User
Not having ever seen one of these I am just guessing.
Have been musing on this and suspect the champher may be merely a de-burring operation!
Why not try just that on one sample and try it out! If it is insufficient, the champher can be made bigger!
Hope that helps and I can't see how it may do any harm!
Pardon me for offering an off-the-wall solution!
atvb
David
May today be the best day of your life and all your tomorrows even better!!
Registered User
Not having ever seen one of these I am just guessing.
Have been musing on this and suspect the champher may be merely a de-burring operation!
Why not try just that on one sample and try it out! If it is insufficient, the champher can be made bigger!
Hope that helps and I can't see how it may do any harm!
Pardon me for offering an off-the-wall solution!
atvb
David
Registered User
Nearly stampeded in the response! However thanks to an enterprising member I have purchased a complete rifle,so problem now solved
Registered User
After a long 2+ years I was able with a little(lot) of help from my friends to get this lovely Model 220 repaired and back into service
http://www.network54.com/Forum/40594...+Final+Chapter
Note if you have a Mod 220 that needs a new part 12 - then pm me for contact details
Registered User
Anshutz 220
Well done Mark good job (You could of bigged me up a bit more) TE He
Registered User
I would also like to add, Ken first done some machining for me over 20 years ago
The standard of his work is second to NONE.
Kens knowledge of engineering is amazing He would never blow his own trumpet
so I will blow it for him
Well done Ken
Registered User
Does anyone know where I can obtain a replacement mainspring for an Anschütz 220?
Millimetres matter
Posting Permissions
Reply With Quote