Bsa ultra filling problem

[bhodge]

https://m.youtube.com/watch?v=P0mi85-t_BM
Here you go, check this out....

[nick-nic]

Before you strip the gun down, connect your air bottle to the gun & start to fill it by giving it a quick, short sharp blast, it might dislodge any crap that is stuck on the fill valve face.
If you are filling with a pump, forget what I have just said!

[arran256]

Thanks for the replys I took the fill valve out and there was a small piece of washer off of the fill probe stuck in there. After putting it back together I can fill to about 100 bar but then it starts leaking out, I guess this could be because of the knick out of the fill probe washer so I'll get a replacement and hopefully that will sort it out...

[radiofan]

Thanks for the replys I took the fill valve out and there was a small piece of washer off of the fill probe stuck in there. After putting it back together I can fill to about 100 bar but then it starts leaking out, I guess this could be because of the knick out of the fill probe washer so I'll get a replacement and hopefully that will sort it out...

The knick can happen if you don't have the probe fully pushed in when filling.

[bhodge]

.... I guess this could be because of the knick out of the fill probe washer so I'll get a replacement and hopefully that will sort it out...

I've got loads of fill probe 'o' rings mate.
PM me your name & address and I'll pop a couple in the post to you foc.
bhodge.

[what barn door]

I've got loads of fill probe 'o' rings mate.
PM me your name & address and I'll pop a couple in the post to you foc.
bhodge.

Top Bloke