Wanted .44 Mag mould, sizer etc

[WarrenC]

As above
Cheers

[tacfoley]

As above
Cheers

Are you sure you want to go with this one?

A mould for making a 240gr .429 bullet out of hard-cast lead is cheap enough - Lee make one for around £25 or so, but the lubrisizer is going to hit you for north of £250........unless you can find one used. That's a LOT of store-bought, prelubed, ready-to-shoot bullets.

tac

[WarrenC]

Yea, I like to make all my gear if poss tac, I'm very surprised at the sizer price. I take it lub o matic etc don't make the punches then either? 250 seems a bit excessive. I've purchased heads but 80 per 1000 seems high from making them and the peace you get doing it, saying that a 250 investment sounds ok haha

[tacfoley]

Yea, I like to make all my gear if poss tac, I'm very surprised at the sizer price. I take it lub o matic etc don't make the punches then either? 250 seems a bit excessive. I've purchased heads but 80 per 1000 seems high from making them and the peace you get doing it, saying that a 250 investment sounds ok haha

You'll need to add the punch and die set to that price.

tac

[loiner1965]

You'll need to add the punch and die set to that price.

tac

join cast boolits and they is a chap called lathesmith i believe who will make them for you
he did them for my lyman and starr sizers

[WarrenC]

That's lovely thanks mate

[tacfoley]

join cast boolits and they is a chap called lathesmith i believe who will make them for you
he did them for my lyman and starr sizers

Now THAT's a useful bit of information - thank you for that!

tac