This is another good resource
http://www.druckluftwaffenonline.de/
Go to the se tion 'Zubehor' for parts
This is another good resource
http://www.druckluftwaffenonline.de/
Go to the se tion 'Zubehor' for parts
Donald
Hi, thanks for all the suggestions for parts, but the wanted part is my signature. I have tried all the "usual suspects" The part is not being produced
and is very hard to get hold of.
My question for this post is about the weight of the FWB 603 without the stock and if the lack of spring and sliding mechanism makes the gun much lighter than a FWB 300s.
I am into the idea of making a lightweight air gun with 300s accuracy. Making a light weight stock.
Cheers for the replies!
Wanted part new/used: Model 65, 80, 90 part 1600.178.1 Führungsachse, hinten ø 4,615 Guide axle, rear, ø 4,615
CO2air.de suggests 4.9kg for the standard FWB603 and (I think) 4.1kg for the Junior version. I can't find the weight of the 300 on their page, but no doubt it's there somewhere. I think it's about the same.
As for a lightweight airgun with the same accuracy as the 300S, try a 300S Junior. Mine: rough and restored.
Matt
I take your point.
It is so difficult to get the correct weight for the gun in its stock with these discontinued models.
To get the weight for the action alone is probably impossible without owning the guns in the first place and weighing them.
I would guess that the action of the 603 might be lighter, but it's just a guess.
The stock on the 603 seems longer and is laminated so it is probably quite heavy.
Arthur
I wish I was in the land of cotton.