Hi
Asked on an earlier thread if someone was willing to repair my pump up pistol
I have had no offers even as I was willing to pay for your time
I have purchased the O rings and have changed them but I still have air blowing out of the barrel after 3 pumps
On the plan of the gun from T W Chambers & Co the end of the exhaust valve looks different from mine
There is the main part of the assembly with a fine hole in the one end and there is a smaller piece that slides on to the other end tube about 3 mm long
It shows it in two parts ,I can not see how to undo this as it looks as there is a small O ring inside and this may be the one that is leaking it looks as if the inside is not brass
Can any one offer some advice
I can send an email with a photo of the part
Thanks
Mick