Anyone do a small lathe job for me?

[Steve A]

Is there anyone on this forum who can make a simple brass collar for me?

Dimensions are approx. OD 30 mm, ID 22.5 mm, width of collar 6mm. 1 mm chamfer on OD, both sides/

Exact dimensions (need to double check the inside diameter) will be posted if anyone comes back to me able to make this.

Of course I would pay for this to be made.

Used to be a turner myself for many years, feel lost without a lathe!

[HW777]

There was a bloke taking over where UK Neil left off, not heard much since though ?

[Steve A]

Cheers, if anyone has a link or phone number for the guy? Please drop me a PM.

[Brian.Samson]

I can 3D print one for you in gold - but it'll be plastic.

If that's any good to you

[thisisdonald]

Sounds like a big olive!... i dont have the brass or confidence to do this first time, but if you are down in paisley you are welcome to show me a thing or two on my old metric boxford cud.

[Steve A]

Sounds like a big olive!... i dont have the brass or confidence to do this first time, but if you are down in paisley you are welcome to show me a thing or two on my old metric boxford cud.

Thanks for the suggestion Donald, you have a PM.

[Steve A]

I can 3D print one for you in gold - but it'll be plastic.

If that's any good to you

Good suggestion - but this part needs a little more strength.

Thanks for the offer.

[lensman57]

Is there anyone on this forum who can make a simple brass collar for me?

Dimensions are approx. OD 30 mm, ID 22.5 mm, width of collar 6mm. 1 mm chamfer on OD, both sides/

Exact dimensions (need to double check the inside diameter) will be posted if anyone comes back to me able to make this.

Of course I would pay for this to be made.

Used to be a turner myself for many years, feel lost without a lathe!

Does it have to be brass? I can do it in Aluminium if it is of any use to you.

A.G

[Steve A]

Does it have to be brass? I can do it in Aluminium if it is of any use to you.

A.G

I can order a short length of 32 mm brass bar and have it delivered to.you. Will send you a PM later with exact dimensions and if its something you can do on your lathe then I will take you up on your offer.

Can arrange beer coupons as restitution as well!

Cheers

Steve

[Martin444]

I can do this for you but I need the exact dims
Just pay for the postage pm me
All the best martin

[Steve A]

I can do this for you but I need the exact dims
Just pay for the postage pm me
All the best martin

Hi Martin, only just seen your reply. Job was just completed by Lensman.
Thanks for your offer anyway.
Steve

[Steve A]

Does it have to be brass? I can do it in Aluminium if it is of any use to you.

A.G

Hi A.G,

Your good work arrived today, BRILLIANT!

Thanks very much, I can now complete my wee mod with a professional finish!

Regards,
Steve

PS - I do not add much myself to this forum but it's seen me through some tough times. Kept my interest in during lengthy bouts of ill health when I could not go shooting. Sometimes forum life is more useful than just the practical stuff we love to discuss