Thank ,Originally Posted by Aimstraight
Will try calling them instead.
Wants something a little...special
Thank ,
Will try calling them instead.
This is the crisis I knew had to come, Distroying the balance Id kept.
Turning around to the next set of lives, Wondering what will come next .
Registered User
How did you get on sourcing the urethane 'O' rings?
Cheers,
Mark
Too many guns, or not enough time?
Registered User
See post #2 of the thread HERE.
Registered User
Very helpful, thank you!
Mark.
Too many guns, or not enough time?
Wants something a little...special
Tried again this morning with the spare piercer, shot twice then makes a louder shot, then it's just like dry firing.
When I go to remove the co2 it is just slowly releasing air, the oring has blown again, I would have thought that the chamber would have been full of air, just a thought , could I be over tightening the piercer??
I think I read that your not supposed to tighten too much with the tool supplied.
Any ideas....running out of o rings, co2, ...and my love for air guns.
This is the crisis I knew had to come, Distroying the balance Id kept.
Turning around to the next set of lives, Wondering what will come next .
Registered User
After piercing the CO2 are you backing of the screw cap a quarter turn to allow a free flow of gas?
Wants something a little...special
In a word ..no
Is this what is causing the problem.
Also what are the best o rings to use.
Cheers
This is the crisis I knew had to come, Distroying the balance Id kept.
Turning around to the next set of lives, Wondering what will come next .
Posting Permissions
Reply With Quote