Relum Pistols + Mainspring scrounge!

[slow_runner]

Yes that forked sear is an interesting concept Guy.
The Hurricane that we have, hereby known as the 'Phutta', has deep axial grooves down the bore. Jeff spent a long time with the lap tool before giving it up and putting it aside for the duration.
It appears that someone has attempted to ream out pitting at the far end and succeeded in screwing up the bore.

Cheers.
-----------------------------------------------------------------------------------------------------
Wanted: rear sight for Milbro Diana MK4, the early slide elevation type. Or images to replicate from.

[ggggr]

A bump if anyone has a suitable mainspring.
Approximately 130mm long 16.1OD and wire 2.1mm thick. Obviously if the spring is longer I could cut it down.
If you can have a look in your old spring boxes
Thanks.

[piggy589]

Hello Guy,I might have offered this to you before.
158mm long,OD 16 and ID 11,28 free coils,any use to you? .

[ggggr]

Yes that forked sear is an interesting concept Guy.
The Hurricane that we have, hereby known as the 'Phutta', has deep axial grooves down the bore. Jeff spent a long time with the lap tool before giving it up and putting it aside for the duration.
It appears that someone has attempted to ream out pitting at the far end and succeeded in screwing up the bore.

Cheers.
-----------------------------------------------------------------------------------------------------
Wanted: rear sight for Milbro Diana MK4, the early slide elevation type. Or images to replicate from.

Ken --could your mate Jeff put a thin walled sleeve down the cylinder and then turn the piston down to suit? Just thinking as a lot of people sleeve the Hw's etc