Case Oil

[1066]

Agree with everything above - No, don't bother making your own lube. I've been using a small shoe polish size tin of Imperial wax for ten years or so - getting a case stuck in the sizing die could spoil your day.

Carbide dies for straight walled cases is the (only) way to go, the Lee ones are excellent value and work very well.

And yes, get some proper advise and do your homework well before you start loading. 50 grains of a pistol powder like Bullseye in a .308 case would be like a hand grenade going off just in front of your nose.

Saying that - .38/357 is a good place to start, it's an easy cartridge to load for with plenty of powder/bullet choice.
Time do some some reading and think about what you want to do with the finished rounds - this might influence the type of press you might need.

[sarge4318]

As stated above your straight walled 38/357 cases won't need lube in a carbide die.

Making your own lube is easy and it smells a lot nicer than the bought stuff. For a few £s you can get a small bottle of Lanolin and the gallon of Isopropyl alcohol (make sure it is 99%+ and not one of the lower concentrations), all you need is a small pump spray bottle (look under your sink, I bet you'll have one in there somewhere) and you'll be good for many 1000's of rounds.

And if the worst hap-pens you can always drink it and die happy but blind.

[tacfoley]

I also suggest that you look up the page about a inch or so and have a read of the sticky that deals specifically with reloading - http://www.airgunbbs.com/showthread....ome-good-links

It's ALL good stuff.

tac

[aquarius11]

I also suggest that you look up the page about a inch or so and have a read of the sticky that deals specifically with reloading - http://www.airgunbbs.com/showthread....ome-good-links

It's ALL good stuff.

tac

One of the first things i did, they are very good but started to watch stuff on utube guess ive watched so, so, so much stuff im confused!!