Digital manipulation should sort it.
Hi, stripping an old HW55, and I have found the piston shaft up the centre of the piston is at quite an angle to one side.
Any ideas how I should get this central again?
Looks like it was dragging up the spring guide and into the trigger block!
Thanks.
Thanks - Geoff.
Digital manipulation should sort it.
My ignore list: <Hidden information>
i.e. hit it?
Thanks - Geoff.
Just use your hands to get it into the right position. Rolling it on a flat surface should help tell if its right
My ignore list: <Hidden information>
I ended up giving a tap with a small rubber faced mallet which got it close, then tweek by hand to get spot on.
Thanks.
Thanks - Geoff.
Proper job!
My ignore list: <Hidden information>