I have to refit my Trackers taploader. It had been removed to deburr.
Whats the best way to refit? The tap seems to rotate along with the retainerscrew, leaving the loading hole in the wrong spot..I did notice the hole on the other side of the taploader but I dont know what goes in. Its not a wrench.
Also, there seems to be a small edge/rim inside the loadinghole of the tap. But the edge is on one side only. What side should this edge be on with taploader opened(=ready to load pellet)? Up or down?
I checked my osprey, but that taploader doesnt show any edge inside. Not visible when fitted anyway. So that suggests its not there or it should be on the down side?