17 hornet Case length trimming

[optima silk]

Hi baldycoot
I have removed the ball bearing and it still spins the case just wondering now if I have the right shell holder mine is H3 size cheers
Regards
Colin

[Ka-Boom!]

Hi baldycoot
I have removed the ball bearing and it still spins the case just wondering now if I have the right shell holder mine is H3 size cheers
Regards
Colin

The correct Lee shell holder is #20.
I had already taken the ball bearing out of mine as it seems to cut a better chamfer with all my cartridges up to .30 cal.
BTW you do need to take off the spacer ring for short cartridges despite the 17 Hornet case being longer than 1.25".
Mine is the Power Trim version and it has been great so far.

[optima silk]

The correct Lee shell holder is #20.
I had already taken the ball bearing out of mine as it seems to cut a better chamfer with all my cartridges up to .30 cal.
BTW you do need to take off the spacer ring for short cartridges despite the 17 Hornet case being longer than 1.25".
Mine is the Power Trim version and it has been great so far.

Hi yeah I too have removed the spacer ring I can only presume that it's not sitting in the hornady shell holder correctly I will try the lee #20 as it's an inexpensive solution if that works .
Thanks for your help guys .
Regards
Colin

[toxo]

Hi yeah I too have removed the spacer ring I can only presume that it's not sitting in the hornady shell holder correctly I will try the lee #20 as it's an inexpensive solution if that works .
Thanks for your help guys .
Regards
Colin

Watching with interest as Just ordered the Lee deluxe for my 17 Hornet.

Have made a tween die to reform 22 hornet cases which works really well and takes them straight down to 17. Now need to anneal, trim and fireform or if I can get the plunger right have a go at hydraulic forming.

I too had issues with the Lee 17 hornet dies. No 2 shellholder instead of 20. Ball bearing missing from the seater die. Snapped decapping pin due the clamp not holding despite two spanners and some strength. To be fair Lee has put everything right. Must've been a Friday afternoon job.