I was asked about a valve tool by a good friend so I've made a few can't put a pic up as photobucket messes my computer up
if you look on cheesebook I have a parts page -peds parts and some pics on there
I was asked about a valve tool by a good friend so I've made a few can't put a pic up as photobucket messes my computer up
if you look on cheesebook I have a parts page -peds parts and some pics on there
You should use imgur for pic hosting, very quick. Do the tools you made look like the original ? I can load pic of these as I got in from the U.S.
Baz
BE AN INDEPENDENT THINKER, DON'T FOLLOW THE CROWD
similar to the factory one with the threaded end so a wing nut can be used to pull sttuborn valve bodies-you need to use a 2" spacer against the back of the tube for the wing nut to act on
I can supply a delrin or ally one but it all adds to the cost -I've only ever had to resort to using the tread once on a crusty 347 as most times the valve body comes out with a wiggle
some pics on my page here https://www.facebook.com/Peds-parts-838257829664690/
Ped, do you make parts for the above ? silencer adapter ? not sure of thread size in the shroud but standard 1/2 unf to mod
only do uprated piston rods at present I may look at doing o ring piston heads in the future
as to silencer adapters they're a lot of work to do I have an original one as a template and a good mate is wanting one so may look at making a couple but have a lot on with the other parts I do
they were making them in Indonesia as a mate imported a few along with ally breech's
I have adapters in stock for Benjamin eb's as392 and post 77 sheridans up to 2nd model c9a's
ped, good stuff in the pics, given me some ideas. My mate has the little 1935 bicycle pumper Benjamin pistol, I did fit a polyurethane seal to it but would like to use your mod. What do you use the HPA bottle on ? Was thinking of doing the same on a Brocock AR12 RA.
Baz
BE AN INDEPENDENT THINKER, DON'T FOLLOW THE CROWD