I've inherited BSA Superstar that needs some TLC.

[martin75]

When my grandfather passed away few years ago, amongst the items that were shared out between the grand children, it was his wish I was to inherit his well cared for .22 BSA Supersport Mk2.

It is a bit harsh to shoot right now using RWS Superdomes, but I'm pretty certain it has never been serviced.

So what I was wondering was, with a full service kit fitted could this rifle be as accurate and consistent as a tuned HW77?

What I especially like about the Superstar is the rotary breech design, two stage trigger and manual rocker safety catch. What are your thoughts on this fine rifle gentlemen? Many thanks. Martin.

[BTDT]

I should start by pointing out that the sum total of my experience of the Superstar was removing the cropped, unfinished aftermarket mainspring from a .25" example yesterday morning, calculating the spring stiffness and preload needed for 11 ft. lb. with the owner's preferred Rhino pellets, shortening the spring and finishing the end, reassembling and testing.

The rifle returned 11 - 11.2 ft. lb., is as consistent as variations in the pellet weight allow, and has a fairly pleasing quick yet gentle shot cycle.

On the basis of my observations, the rifle shoots well in the large calibre, but is let down by the trigger. I would not put it in the same class as an HW77.

Nonetheless, your grandfather's rifle is well worth working on. I would start by checking the piston and breech seals, as in .22" it should not be harsh, suggesting air leakage.

[Jimny4x4]

There is a mention on another thread about this super airgun and the other one , the Goldstar .
BTDT can you advise on any methodolgy to remove the rubber mounted scope rail ?
As just mentioned on my post elsewhere literally a few minutes ago , I have seen these rails whacked off leaving them cracked ( they are made from alloy ) .

[BTDT]

There is a mention on another thread about this super airgun and the other one , the Goldstar .
BTDT can you advise on any methodolgy to remove the rubber mounted scope rail ?
As just mentioned on my post elsewhere literally a few minutes ago , I have seen these rails whacked off leaving them cracked ( they are made from alloy ) .

I drifted the rail off a Lightning XL in the traditional manner using a lump of Delrin and a hammer some years ago, but then discovered that I could use a sash cramp, both to remove and refit.

[martin75]

Thank you gentlemen for all of your constructive useful replies. I have chronograph the Superstar and it averaged out over 20 shots at 610 FPS. It just has a lot of vibration upon firing, which is the harshness I was referring to. The two stage trigger is nice and predictable though, well up to sporting use I would of thought? The thing to remember though is the rifle was stored away for many years mostly because of granddads ill health and is probably as dry as a bone internally, even reasonably still smooth to cock without any graunching noises; the rotating breech is quite stiff though and I know you mustn't try and rotate until the action is in the fully cocked state. Granddad always reminded me and my cousins about this and how it would strip the breech washer! As a precaution, I've decided not to shoot it any more until it has been serviced by myself, or preferably a gun smith. Thank you again every one. Kind regards. Martin

[Jimny4x4]

I drifted the rail off a Lightning XL in the traditional manner using a lump of Delrin and a hammer some years ago, but then discovered that I could use a sash cramp, both to remove and refit.

Thanks ! Never though of a sash cramp .

[look no hands]

I always found the triggers excellent on the Superstars and can say they are well up there with the Rekord unit, may be I was lucky and had a good one but I can also say that I've had some horrid Rekord units as well.

Pete

[I. J.]

An added bonus of the Superstar is that its one of the safest rifles (to cock) with no fingers going anywhere near the man traps of some other designs.

I have to agree with the very learned previous poster (BTDT) with regards to the trigger and comparison to the HW77.

ATB
Ian