Browning t bolt .22 or and hmr sorter composit

[bear-uk]

I like my .22 Tbolt. Its as accurate as my CZ and a lot lighter to carry around. Still a bit stiff at the mo but hopefully it will ease up a bit on the bolt.
I altered the trigger pull just by removing a lip where the spring sits so its now sitting flush with the housing.

[Whitester]

Did the trigger mod make much of a difference ?

[bear-uk]

I think so but havent got anything to measure the pull.
I used a hot Stanley knife blade to cut the lip off. When you back off the adjuster screw the lip stops the spring from fully unwinding.

[Whitester]

Ok thanks that's good to know, I presume that the trigger group is fairly easy to take apart?

[bear-uk]

yes, its all plastic and unclips. Security foil seal tape to undo. Pretty naff really considering its made by Browning and Miroku. Usual polish of sears helps to smooth the action out a bit.

[Whitester]

Lovely , cheers mate 👍

[JustinThyme]

Just done the same mod on the trigger housing and also removed the adjusting screw whilst at it so the spring now sits down on top of the threaded brass insert that the screw resides in, trigger pull now at 3.5lbs as opposed to over 6lbs which was lightest pull setting when adjusted from standard, not polished anything as happy with result and just lubed sears and pivot point and put back together.

Had rifle from new and very happy with it apart from the heavy trigger but wantedto wait until out of warranty before modifying, was hoping to get out with it this afternoon/evening for a play ..... sat here now waiting for rain to pass