-
Tx 200 grub screw
I have a TX 200 HC and one of the grub screws that holds the knurled had part on the cocking link
is rounded and I'm unable to remove to replace it, what's the best way to remove the small grub screw?????
-
get a suitable torx bit and tap (hammer) it in . then use it to undo the grubscrew
or a left hand drill bit smaller than the threaded hole but fits the hole in the grub screw.it may get it out as it cuts.
https://upload.wikimedia.org/wikiped...20-T25-T30.jpg
torx bits.
if its loctited in then thats another problem .a heat gun may loosen the glue.
Last edited by bighit; 30-09-2017 at 07:25 PM.
-
No it isn't loctited in I know that because It was me being heavy handed tightening it up
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules