Results 1 to 3 of 3

Thread: Tx 200 grub screw

  1. 30-09-2017, 06:48 PM #1
    KeithS
    KeithS is offline Registered User
    Join Date
    Jan 2010
    Location
    Hull
    Posts
    1,084

    Tx 200 grub screw

    I have a TX 200 HC and one of the grub screws that holds the knurled had part on the cocking link
    is rounded and I'm unable to remove to replace it, what's the best way to remove the small grub screw?????
    Reply With Quote Reply With Quote
  2. 30-09-2017, 07:17 PM #2
    bighit
    bighit is offline Guest
    Join Date
    Oct 2009
    Location
    aberdeenshire
    Posts
    25,209
    get a suitable torx bit and tap (hammer) it in . then use it to undo the grubscrew

    or a left hand drill bit smaller than the threaded hole but fits the hole in the grub screw.it may get it out as it cuts.

    https://upload.wikimedia.org/wikiped...20-T25-T30.jpg
    torx bits.

    if its loctited in then thats another problem .a heat gun may loosen the glue.
    Last edited by bighit; 30-09-2017 at 07:25 PM.
    Reply With Quote Reply With Quote
  3. 30-09-2017, 07:34 PM #3
    KeithS
    KeithS is offline Registered User
    Join Date
    Jan 2010
    Location
    Hull
    Posts
    1,084
    No it isn't loctited in I know that because It was me being heavy handed tightening it up
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules