If your using new case i would use the lee tool on the inside and outside of the neck, to stop the case splitting, Just to take the sharp edge off
If your using new case i would use the lee tool on the inside and outside of the neck, to stop the case splitting, Just to take the sharp edge off
Thanks for the replies guys. I'll probably give Starline a whirl.
Simon, when you say the "Lee tool" on the inside & outside of the neck do you mean a chamfer/duburr tool?
Cheers
Greg
there is some Federal for sale on gun trader,
Yes mate, this is it 1 or 2 turns will do it. I use Starline brass
I also use PPU brass in my 357mag
http://www.henrykrank.com/index.php?...oducts_id=1592
The Brass
http://www.henrykrank.com/index.php?...oducts_id=1036
Last edited by Simon_S; 19-09-2017 at 04:12 AM.
Another one for Star-line. Iv used them with black powder and nitro loads and found them excellent. Tim
I use light load of Trailboss in my rifle, its like black powder but don't have piss out cleaning it
You get over 350 loads out of bottle. it work out cheaper
Last edited by Simon_S; 19-09-2017 at 09:25 AM.
I use Starline brass and Lee dies both available from Henry Krank, not had any issues with them.