All the screws are tight on the mag holder and it indexes ok with the other mag?
All the screws are tight on the mag holder and it indexes ok with the other mag?
If it's the two part stock model then you can get access to the magazine adjuster screw very easily. The single piece stock types need the stock removing first.
Look at the magazine as you cycle the action; does it move when you close the bolt, either left or right? If it does, then the throw of the indexer needs to be adjusted, just turn the screw say half a turn and see what happens, you may have turned it the right way or the wrong way.
The "straight ahead" point can be rather vague and you may find that once you are set right, a quarter turn either way seems to make no difference.
The other issue can be wear in the U shaped slot that the spigot on the back of the magazine runs in. Once the plastic chassis has worn away it's a bin time but yours is a new rifle..
www.shebbearshooters.co.uk. Ask for Rich and try the coffee
yup seems ok on one of the mags and mine is the 1 piece stock.22 sporter
I Thankyou
no aimstraight just thanking people for there help hope to look into the problem Tuesday when I have some time to myself
As it now seems to be one mag at fault would it be worth cleanining it up with very fine wire wool or getting it replaced? should be under warranty not quite 6 months old,