AA s200 magazine problem

[oldboyshooter]

if you mean the 10 shot mag conversion they can have problems if not correctly fitted, the indexing system that turns the mag can get bent, the mags are not the best quality, i would suggest you take off and check all parts if every thing ok replace with bolt through then tighten holding screws, once it aligns good after you trial without pellets, use pellet lube and they are better with shorter domed pellets, good luck from the oldy

[Aimstraight]

if you mean the 10 shot mag conversion they can have problems if not correctly fitted, the indexing system that turns the mag can get bent, the mags are not the best quality, i would suggest you take off and check all parts if every thing ok replace with bolt through then tighten holding screws, once it aligns good after you trial without pellets, use pellet lube and they are better with shorter domed pellets, good luck from the oldy

Sounds sensible, any suggested brand of pellet lube (Napier or A.N.Other)?

[oldboyshooter]

Sounds sensible, any suggested brand of pellet lube (Napier or A.N.Other)?

hello, you cannot beat LT 1 lube 100ml bottle spray, should find it on the bay eeeeee for a tenner, been using it for years, do a search on here ukgunlube

[Aimstraight]

hello, you cannot beat LT 1 lube 100ml bottle spray, should find it on the bay eeeeee for a tenner, been using it for years, do a search on here ukgunlube

Thanks for the response.

[oldboyshooter]

Thanks for the response.

ok dont be mean with the spray 3 or 4 pumps in a half full tin swirl around, some wash their pellets first but i find AA field good straight out of tin. i leave the foam ring in bottom which helps, i dont worry on a bit oily fingers, also good to keep barrel clean

[Gerard c.]

Thanks everyone will consider all the answers and work through them one by one including drilling woodwork and report back on conclusions/ solution

[Gerard c.]

All the screws are tight on the mag holder and it indexes ok with the other mag?

I can now confirm one mag works fine

[Gerard c.]

As it now seems to be one mag at fault would it be worth cleanining it up with very fine wire wool or getting it replaced? should be under warranty not quite 6 months old,