Hw35 Leather or synthetic piston seal ?

[johnbaz]

How about machining a new piston head to take an O ring?

I have this tuned one and it's smoother than a wench's inner thigh, It shoiots superbly too

Pic 1

Pic 2

I made one of these for an airsporter mk1 as the leather seal was kaput although it wasn't as good as the one in the HW35

Pic 1

Pic 2




John

[T 20]

How about machining a new piston head to take an O ring?

I have this tuned one and it's smoother than a wench's inner thigh, It shoiots superbly too

Pic 1

Pic 2

I have already done that, John

http://www.airgunbbs.com/showthread....10#post2931510

The finished gun and piston was shown in Jim's Real Airgun Sport.

Unfortunately my doctor won't allow me to use any machinery that I could fall into and kill myself at present, so I couldn't offer to make Les an O ring piston head.



All the best Mick

[I. J.]

IMO - keep original.

[johnbaz]

I have already done that, John

http://www.airgunbbs.com/showthread....10#post2931510

The finished gun and piston was shown in Jim's Real Airgun Sport.

Unfortunately my doctor won't allow me to use any machinery that I could fall into and kill myself at present, so I couldn't offer to make Les an O ring piston head.



All the best Mick

Crumbs Mick, Take it easy mate, There's always later to play on your lathes/Millers!

My old Faircut lathe is worn out, I have a nice 1950's Myford that's nice and tight on the ways but no room to get it set up until I clear the garage somewhat!



John..

[Peter Dunkley]

Crumbs Mick, Take it easy mate, There's always later to play on your lathes/Millers!

My old Faircut lathe is worn out, I have a nice 1950's Myford that's nice and tight on the ways but no room to get it set up until I clear the garage somewhat!



John..