Hw99 moderator or shroud

[bighit]

Thanks

Good point. I might accept filing off the grooves is inevitable.

I'll have a Google for push on types in 15mm. I suppose once it's on, I won't be taking it off again
https://m.pellpax.co.uk/airguns/air-...silencer/14870

konceptus ones are supposed to be good and can be sent directly to your door where as you cant do the same if you buy one in the uk unless you get it sent to an RFD. Or pay £15 for pellpax to deliver it .

https://www.airgun-konceptus.com/ste...l-hole-push-on

They do other sizes too.

[dayglowfroggy]

I just bought one off those adaptors of then tapped it on with a bit of wood so the grooves are still there untouched.
Don't Think it will come off without cutting it probably but the adaptors are only about 5 pound .
The moderator makes my .177 99 much quieter.

[10/10]

where can i get an slip on adapter to fit my 99 without damaging front sight grooves

[bighit]

where can i get an slip on adapter to fit my 99 without damaging front sight grooves

I don't think there is one other than the HW push on silencer/moderator.

You could get a set of needle files and cut grooves in the adaptor as has been stated on this thread or file the barrel.

As far as I know it's the only ways to do it. Or tap it on like dayglowfroggy and hope it lines up right with no clipping of the pellets inside the silencer/moderator.

[10/10]

Someone does one as i have one on another 99

[trowel]

As I mentioned on a previous thread a while back regarding the HW99s and moderators. I bought a MWSS200 off here and fitted it without touching the barrel grooves as it had corresponding grooves internally. Slides on and fixed with grub screw.

[dayglowfroggy]

The one i tapped on came from the e bay for around a £5 pound it was not hard to do! I would be thought that the front sight Grove cut into the inside of the adapter some they are hard steel and it's not.