-
There are 10 o rings in a HW100 regulator any one of them failing will give you an air leak Buddy
Repeated below from the WOC is the list of o rings
Here's the full list of factory O-rings and some recommended alternatives All O-rings are NBR 70 unless otherwise stated.
O-ring HW 100, 37.1 x 1.6 Cylinder clamp 2682C
O-ring HW 100, 15.6 x 2.5 Barrel clamp 2682B
O-ring HW 100, 32 x 2.5 (or BS#124) Magazine 2603A*
O-ring HW 100, 13 x 2 Adaptor A 2704
O-ring HW 100, 2.57 x 1.78 Adaptor B 2703B
O-ring HW 100, 3 x 1.5 (PTFE) Valve stem 2655D
O-ring HW 100, 12 x 1.2 Breech block main (12 x 1) recommended 2658
O-ring HW 100, 5.5 x 1 Breech/probe seal .22 2659A*
O-ring HW 100, 4.5 x 1 Breech/probe seal .177 2659A*
O-ring HW 100, 4 x 1.5 Probe buffer 2618A*
O-ring HW 100, 2.57 x 1.78 (PUR70) recommended Main valve inlet 2665D
O-ring HW 100, 7 x 1.5 Main valve outlet 2666
O-ring HW 100, 2 x 2 Main valve internal (2.57 x 1.78) recommended N/A
O-ring HW 100, 7 x 1.5 Regulator piston 2668
O-ring HW 100, 10 x 1.5 Tension adjuster (sometimes omitted) 2672
O-ring HW 100, 8 x 1.5 Barrel 2679
The only one missing is the 14 x 1.5 where the main valve assembly screws up inside the Reg block insert inside 2673 (Later quick fill models)
Last edited by Scrinja; 20-01-2018 at 01:10 PM.
Blowing out my candle wont make yours Burn any Brighter
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules