Quote Originally Posted by dunganick
i went for a semi fancy grade walnut dual grip stock, with rosewood tips and caps. varmint forend.

cant wait.

the pillars might actually be very helpful, did you open up the holes much?

if so just with a standard drill bit?
Just a little, as the lightweight is Soooooo light it's soft

Just used a piller drill (Duh!) with the stock upside down, then a little finishing with a large rat tail file, the front is a tight fit and the rear stays in but can slide out when pushed with a pencil etc. I did this to stop the stress' opening up the stock anymore

If you were closer I could have made the pillars up for you on the lathe