Thanks, rifle is used, but has been fitted with a new barrel & mod, i will take it up with the gunsmith who did the work, there won't be any issues he's good bloke, but just thought there might be a quick fix i could.
Regards,
Rob
Thanks, rifle is used, but has been fitted with a new barrel & mod, i will take it up with the gunsmith who did the work, there won't be any issues he's good bloke, but just thought there might be a quick fix i could.
Regards,
Rob
easy on a break barrel to see - just remove the barrel and look through the barrel, from breach to muzzle. you will see if the bore through the mod is off centre - but easiest in good light. Easiest way to fit after correcing and simple misalignment flaws in to spin up the barrel with mode fitted in a lathe, and just bore a fraction out through the mod.. assuming of course the bore is co-encentric. Or just open out the mod - springers don;t need such tight clearances as PCPs - opening it out to 8 or 9mm through the mod will be just fine.
Always looking for any cheap, interesting, knackered "project" guns. Thanks, JB.
Not sure of the make of the mod.
Removed the baffle & that was the cause of the issue, gunsmith has already told me to send the baffle back & he will supply another.
Thanks for the advice.
Rob
What type of baffle ? most airgun mod's use "hair-curlers & washers" I wonder if it's a SAK with a metal insert.
Not sure how to describe it, but its 60mm long plastic & solid other than 24 holes in it.
Rob