lyman 4500 lube sizer heater

[Glevum]

i have that version too but cannot source a pin heater but was quoted £85 for the heated base plate

You can get the pin heaters for 3D printers on for about a fiver. They are normally around 20W which is the same power as the Lyman heater.

They are normally 12V so you will need a power supply to run it.

[loiner1965]

You can get the pin heaters for 3D printers on for about a fiver. They are normally around 20W which is the same power as the Lyman heater.

They are normally 12V so you will need a power supply to run it.

bought a 40 w 12v and it works a treat.....

[stonecutter]

Hi guys, interested in the above thread can anybody provide some more info and some pics regarding the pin heater and how it works please. cheers

[loiner1965]

Hi guys, interested in the above thread can anybody provide some more info and some pics regarding the pin heater and how it works please. cheers

i bought this off the auction site ......item number 122904053273
connect via an illuminated 12v switch and 12v power supply.....wether a bike / car battery or 12v transformer with good output supply.
warms up is around 20 mins

[stonecutter]

i bought this off the auction site ......item number 122904053273
connect via an illuminated 12v switch and 12v power supply.....wether a bike / car battery or 12v transformer with good output supply.
warms up is around 20 mins

Thanks for the info 👍
Did you drill into the machine or a metal block and then place then place lube sizer on top? Cheers