Hi all own a hft 500 but really not keen on the triger button/bullet size feels clumsy to me,
I like triger buttons and similiar etc just not tht big.
Has anyone changed theres if so what did you use or what do you recomend..
Atb mike
Hi all own a hft 500 but really not keen on the triger button/bullet size feels clumsy to me,
I like triger buttons and similiar etc just not tht big.
Has anyone changed theres if so what did you use or what do you recomend..
Atb mike
Try turning the standard button round - it's smaller on the other side and a whole lot cheaper than a new trigger blade.
Hi brian its not so much the lenth its the diamter i jad a button on an old rifle and it was alot smaller in diamter and fitted me perfect but dont belive it would fit this rifle (was on a bsa r10 se)
Buy a Rowan Engineering replacement blade for an MPR - it's a direct fit and a much nicer feel. Personally I don't like button triggers at all and I don't think they help with a consistent trigger release at all.
The MPR blade from Rowan is £25
Just take the button off, and use the rod as your trigger.
Steve C.
AirArms S400k L/H (.177)BTAS, tuned, AirArms S410k L/H (.177) walnut, BTAS tuned, AA MPR .177 L/H walnut (STOLEN) and...L/H EV2
BASC
Once I fitted a small fat O ring over a trigger post, found the height that was most comfortable then covered the whole lot with a piece of heat shrink tubing. Looked like a black anodized custom trigger, cost almost nothing.