Results 1 to 6 of 6

Thread: Air arms hft 500 trigger

  1. #1
    Join Date
    Feb 2007
    Location
    basildon essex
    Posts
    389

    Air arms hft 500 trigger

    Hi all own a hft 500 but really not keen on the triger button/bullet size feels clumsy to me,


    I like triger buttons and similiar etc just not tht big.


    Has anyone changed theres if so what did you use or what do you recomend..


    Atb mike

  2. #2
    Join Date
    Mar 2005
    Location
    Doncaster
    Posts
    3,487
    Try turning the standard button round - it's smaller on the other side and a whole lot cheaper than a new trigger blade.

  3. #3
    Join Date
    Feb 2007
    Location
    basildon essex
    Posts
    389
    Hi brian its not so much the lenth its the diamter i jad a button on an old rifle and it was alot smaller in diamter and fitted me perfect but dont belive it would fit this rifle (was on a bsa r10 se)

  4. #4
    Join Date
    Mar 2005
    Location
    Doncaster
    Posts
    3,487
    Buy a Rowan Engineering replacement blade for an MPR - it's a direct fit and a much nicer feel. Personally I don't like button triggers at all and I don't think they help with a consistent trigger release at all.

    The MPR blade from Rowan is £25

  5. #5
    Join Date
    Aug 2006
    Location
    Leek, Staffs.
    Posts
    2,348
    Just take the button off, and use the rod as your trigger.

    Steve C.
    AirArms S400k L/H (.177)BTAS, tuned, AirArms S410k L/H (.177) walnut, BTAS tuned, AA MPR .177 L/H walnut (STOLEN) and...L/H EV2
    BASC

  6. #6
    Join Date
    Jun 2009
    Location
    Haywards Heath
    Posts
    1,165
    Once I fitted a small fat O ring over a trigger post, found the height that was most comfortable then covered the whole lot with a piece of heat shrink tubing. Looked like a black anodized custom trigger, cost almost nothing.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •