Hw99 cocking lever replacement

[TonyL]

Excellent information, peeps; thank you.

[look no hands]

Or you could just buy a new Diana and the pin will just fall out

Yes I said it.

Pete

[rg627]

Thanks guys

[Arthur John Smithsplease]

Once you get the pin out, it's better to replace it with one of these to make the whole procedure easier in the future:

https://www.trrobb.com/Weihrauch_Qui..._13107089.aspx

Vtech also do one.

[deejayuu]

As Baz says. Would just add that you can stick a ball bearing each side with grease or even cellotape then crush in the vice or clamp.
The tape is good if hitting with a hammer.

[PhatMan]

rg627,

+1 on Shauny's take down pin.

The VMach pin uses a very small screw to secure, and there have been reports that these are sometimes very difficult to remove if the user was 'enthusiastic' when installing.

Shauny's pins are 300 series stainless, and use a single circlip to secure and I highly recommended them.

(My three (3) HW break barrel's all have Shauny pins.)

Have fun & a good Sunday

Best regards

Russ

[TonyL]

Shauny was doing them too Tony .

rg627,

+1 on Shauny's take down pin.

The VMach pin uses a very small screw to secure, and there have been reports that these are sometimes very difficult to remove if the user was 'enthusiastic' when installing.

Shauny's pins are 300 series stainless, and use a single circlip to secure and I highly recommended them.

(My three (3) HW break barrel's all have Shauny pins.)

Have fun & a good Sunday

Best regards

Russ

Cheers, people. Very useful info.