Hi, short is no, sorry.
As far as I remember the cylinder is all one piece on a classic and is two-piece on the Regal, inletting of stock is different as well on Regal.
Hi, short is no, sorry.
As far as I remember the cylinder is all one piece on a classic and is two-piece on the Regal, inletting of stock is different as well on Regal.
Daystate Owners Club new site: www.daystateownersclub.com/forum
"corners should be round" Theo Evo .22/.177 - Meopta 6x42, DS huntsman classic .20 vortex razor LH 3-15x42 under supervised boingrati tuning by Tony L & Tinbum, HW77 forest green - Nikon prostaff 2-7x32 plex.
Daystate Owners Club new site: www.daystateownersclub.com/forum
"corners should be round" Theo Evo .22/.177 - Meopta 6x42, DS huntsman classic .20 vortex razor LH 3-15x42 under supervised boingrati tuning by Tony L & Tinbum, HW77 forest green - Nikon prostaff 2-7x32 plex.
The barrels already quite short on those, best thing you can do is shorten the shroud from the rear you can take about 3" from it, makes a good improvement on accuracy too, if done properly as there can be misalignment from shroud to silencer issues on these as well as all shrouded barrels.It helps make it a better hunting tool too being shorter obviously.
"corners should be round" Theo Evo .22/.177 - Meopta 6x42, DS huntsman classic .20 vortex razor LH 3-15x42 under supervised boingrati tuning by Tony L & Tinbum, HW77 forest green - Nikon prostaff 2-7x32 plex.