Results 1 to 7 of 7

Thread: rebuild of a 67 Sheridan

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. 28-04-2018, 03:58 PM #3
    --ped--
    --ped-- is offline Registered User
    Join Date
    Dec 2016
    Location
    leeds
    Posts
    2,069
    not much more to do Stu I made a rivet from a nail for the front trigger guard fixing
    i'll be using a crosman 2200 hammer spring with a adjustable preload adjuster that fit's in the trigger housing
    my biggest headache is the foresight as it had been snapped off and a huge bit of brass had been soldered on,the problem is it should slope to the rear for it to be as original and this slopes to the front
    it's going to be a bit of adlib unless I redo it but for the time being i'll trim it to as close as original (as I can determine) with a slight scallop out of the front
    https://imgur.com/qSxjeJE
    Last edited by --ped--; 28-04-2018 at 04:42 PM.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules