Hawke Scope Question?

[luckymjr]

Hi all

I've recently bought a Hawke 2-7x32 scope for one of my air rifles and I have a question. Basically, I was just wondering If you have to centre the crosshairs yourself before zeroing the rifle with a Hawke or do Hawke usually do this back at the factory. The reason I'm asking Is because I've had scopes before that seemed to be pretty much centered once I checked the zero for the first time. As I've never bought a hawke before I'm just a bit curious,

Atb,

John

[angrybear]

I've never done anything more than bolt them straight on & zero the rifle starting at about 10yds with an A4 size target.

If you want to count the clicks & centre it there's nothing stopping you, but there's no need or benefit to doing it, it will align with the barrel at the same point regardless.

[Portzy]

From what I read somewhere, Hawke assemble their scopes pretty much mechanically centred but do not guarantee 100% perfect. As post above, if you want to do this yourself just adjust until you reach the stops, but don't apply any excessive force when you reach the stops, then go the other way while noting the number of "clicks" then come back half that number.

[luckymjr]

Thanks for the replys and Info lads,

John 👍

[HW777]

Probably better for the scope to centre the ret by putting it in a V block and rotating the scope, sighting at a fixed object of known or set distance.

[angrybear]

Probably better for the scope to centre the ret by putting it in a V block and rotating the scope, sighting at a fixed object of known or set distance.

Please tell me the point in "centering the ret"

Once it's fitted to the rifle the adjustment to zero the POA to the POI will be what it will be, for that combination.
I really cannot see what difference faffing about before fitting makes to matters