If they work -none
If they work -none
That’s great, thanks for your help
These pistols just keep on going, and if they worked fine before probably no action required. If you find that the slide release catch is stiff/problematic, remove the slide (easy job) and put a smear of grease on the vertical plates that lock the slide; that will transform one that is problematic.
Treat Others As You Would Wish To Be Treated.
The most number of repairs I get on these pistols is the bending of the pressure plate because owners over tighten the brass nut before closing the lever. When the pressure plate gets slightly bent it "over cams" and drops the capsule nozzle back a few thou off the seal and the gas leaks. Immediately they think the seal is worn which it isn't. I just re-bend the Zamak casting and try to re-educate the user.
Baz
BE AN INDEPENDENT THINKER, DON'T FOLLOW THE CROWD
The one with the brass screw in, it deforms and causes the brass screw to bind If you try to straighten it you'll more than likely snap it so just remove the brass screw and grind a bit of the casting away to allow the screw to come out fully. You can get get away with that a couple of times then you'll need a new pusher plate.
You want it fixed when??!