Where can we get target holders like this?

[angrybear]

Looks a bit like the gamo one that contains 4 or 5 knockdowns.

[bullbarrel]

Looks a bit like the gamo one that contains 4 or 5 knockdowns.

Like this. But with the front removed.

[Solvo]

Looks unusually wide.
A modern single target version is the Do-All Bullet Box:
https://www.academy.com/shop/pdp/do-...ber-bullet-box

I suspect you'll have to get them fabricated if they have to be that size.
If they were folded from say 3mm steel plate and skipped the end plates (overkill if you use 3mm) it should be very cheap.

[Rich]

Hate to disagree but after running an indoor range for ten years can I say that 3mm is not overkill unless you are only shooting 6ft.lb.

We've moved away from 3mm in some cases as constant impact in one place by 177 and 22 pellets from 12ft.lb rifles bends it. Our LSR boxes (20 yards range) are now being fitted with 5mm backplates.

We made a number of boxes from 12mm ply sides and a steel backplate. 177 pellets hit the backplate and shatter into tiny shards of lead which fly off sideways at roughly 90 degrees. These shards have eroded the 12mm ply and in one case we found last month, only one lamination of ply to go before there was a hole in the side of the box.

[English]

You try a local fabricator.

Someone like this :

http://www.ifabperth.co.uk/

I don't know them and have never used them but this sort of company would be able to make them for you?

There are lots of others if you google fabricators?

Good luck!

[angrybear]

If you're going to have them custom built, you could save a bit & think to the future by having the main box made from 2mm but have rails either side of the rear so that you can slide & bolt in a second heavier 4-5MM sheet as the "strike panel" (with a gap between the two) which can then be easily replaced rather than replace the whole box.

[DedIdick]

You try a local fabricator.

Someone like this :

http://www.ifabperth.co.uk/

I don't know them and have never used them but this sort of company would be able to make them for you?

There are lots of others if you google fabricators?

Good luck!

Aye, our local smiddy (aka Agricultural Engineers) would soon knock you up a similar one...…….

[Archer50]

Thanks guys. We just wanted to see if there was anything like these holders available off-the-shelf before talking to our local metal bashers. Seems like there isn't.

Cheers

Alan